← Back to Check a domain

DMARC only watches because of a mistake

Receivers aren't applying the policy your record names. A typo in one of its policy values means they read it as p=none, and your record no longer asks them to hold or refuse forged mail.

DMARC only watches
A mistake in the record makes receivers treat it as watch-only: mail pretending to be you is still delivered.
Receivers act as if this record said p=none: invalid p= value rejct.

The third line names the value. It sits in p=, sp= or np=, and isn't exactly none, quarantine or reject: p=rejct, sp=yes, or a capital letter, as in p=Reject. Capitals are a special case: see Receivers ignore your DMARC record.

RFC 9989 section 4.10.1 sets the rule. When the record holds at least one valid report address, "the Mail Receiver MUST act as if a record containing "p=none" was retrieved". The whole policy drops to none: valid sp= and np= values go with it. Without a valid report address, receivers ignore the record entirely.

Correct it

Look the record up first, with your domain in place of example.com:

dig +short TXT _dmarc.example.com

Details → on your result shows the same record.

If the only mistake is a capital letter, as in p=Reject, receivers that follow the standard already apply your policy as written. Write it in lower case, p=reject, and run the check again; nothing else changes.

Any other typo means your record asks receivers to refuse nothing today. Correcting it puts your policy into force at once, so first make sure your own mail passes:

  1. Read your DMARC reports and check that each service you send through passes SPF or DKIM for your domain.
  2. List the services the reports may miss, such as invoicing that sends once a month, and confirm each one.
  3. At your DNS provider, edit the TXT record at _dmarc. in front of the domain you checked. Many DNS providers want only the part before your main domain: _dmarc for example.com, _dmarc.mail for mail.example.com. If everything passes, change the value the result names, for example p=rejct to p=reject. If you aren't sure, set every policy in the record to none for now: p=none, and sp=none and np=none if the record has those tags. Receivers then behave as they do today, and the record says what you mean. Fixing only the typo isn't enough: with p=reject; sp=yes, changing sp=yes to sp=none puts p=reject into force at once.
  4. Run the check again.

Last updated .