# Some DMARC values are invalid

Your policy applies, but receivers skip some of the record's other values. For each one they use a default, which may not be what you meant.

```
Some DMARC values are invalid
Receivers ignore those values and use their defaults, which may not be what you meant.
Receivers use the default for each invalid value: invalid rua= address.
```

A frequent cause is a report address without `mailto:`, as in `rua=reports@example.com`. Receivers send nothing to it, so you get no reports and the record looks fine.

[RFC 9989 section 4.8](https://www.rfc-editor.org/rfc/rfc9989.html#section-4.8) sets the rule: "Syntax errors in the remainder of the record MUST be discarded in favor of default values (if any) or ignored outright." What the check looks at, and what a receiver does with a bad value:

| What the result names | Valid values | A receiver uses |
|---|---|---|
| `adkim`, `aspf` | `r` or `s` | relaxed alignment, `r` |
| `rua` | addresses such as `mailto:reports@example.com`, separated by commas | no reports to that address |
| `ruf` | the same | no failure reports to that address |
| `fo` | `0`, `1`, `d` and `s`, separated by colons, each once; not `0` and `1` together | `0` |
| `psd` | `y`, `n` or `u` | `u` |
| `t` | `y` or `n` | `n` |
| `malformed tag` | a part with no `=` | nothing: it is skipped |

The check reads `adkim`, `aspf` and the policy values in lower case only, so it also names `adkim=S`. A receiver that follows the standard accepts either case; lower case keeps every reader in agreement.

A `malformed tag` is usually a stray word or a missing `=`, as in `v=DMARC1; p=none; rua mailto:reports@example.com`. Write it as `tag=value` or delete it.

## Correct the values

1. Read the record: open **Details →** on your result, or run `dig +short TXT _dmarc.example.com` with your domain in place of `example.com`.
2. At your DNS provider, edit the TXT record at `_dmarc.` in front of the domain you checked. Many DNS providers want only the part before your main domain: `_dmarc` for `example.com`, `_dmarc.mail` for `mail.example.com`. Correct each value the result names, using the table.
3. Run the check again.
